Hänger sig - Svenska 3D-Tåg

Rojje · 2004-06-13, 15:56

Kan du möjligtvis ha råkat ut för samma problem som i denna tråd, http://msts.e-buzz.net/forum/topic.asp?TOPIC_ID=9427 ?

Om du har det kan detta vara svaret på ditt problem, taget från Aurans forum (länk till inlägget finns i tråden ovan):

Hi luddis

Well, I suppose it's some small consolation to know the problem is not just mine. What's annoying me is, I am using only TRS2004 objects - no custom objects whatsoever!

I managed to make some headway using the following method:

1. In Surveyor, create a new single baseboard map using the same region, scale and measurement units as your problem map, but don't save it yet
2. Click on "merge route" and select your problem map
3. Use the arrows so that the blank single baseboard is attached to your problem map at one end
4. Now delete the blank baseboard leaving your old map as it previously was
5. Change environment parameters (sky, water etc) to suit
6. I found some signals and track markers had moved from their original position - why?
7. Save the map

I found this made an unbelievable INCREDIBLE difference to frame rate in Surveyor and I could make changes and save without crashing. Whether this is a permanant solution, is yet to be seen.

Cheers
Gary

Roger

Liknande ämnen
Ämne	Startat av	Forum	Svar	Senaste inlägg
Det hänger i luften...	Byggare Bob	Off-topic	1	2004-11-13 08:41
Hänger sej efter 1 minut	Blappe	Trainz - Allmänt om Trainz	17	2003-05-29 18:08
MSTS Hänger!	Dson	MS Trainsimulator - Allmänt om MS Trainsimulator / Open Rails	8	2003-04-07 23:43
MSTS hänger sig när den laddar JBJ.	Dson	Landskapsdesign - MSTS / Open Rails	8	2002-09-17 15:13
MSTS hänger sig när det laddar min route /Zzarr :(	Zzarr	Landskapsdesign - MSTS / Open Rails	43	2002-08-16 17:50

2004-06-13, 15:56	#1
Rojje Hedersmedlem Reg.datum: Jan 2002 Ort: Stockholm Inlägg: 732	Kan du möjligtvis ha råkat ut för samma problem som i denna tråd, http://msts.e-buzz.net/forum/topic.asp?TOPIC_ID=9427 ? Om du har det kan detta vara svaret på ditt problem, taget från Aurans forum (länk till inlägget finns i tråden ovan): Hi luddis Well, I suppose it's some small consolation to know the problem is not just mine. What's annoying me is, I am using only TRS2004 objects - no custom objects whatsoever! I managed to make some headway using the following method: 1. In Surveyor, create a new single baseboard map using the same region, scale and measurement units as your problem map, but don't save it yet 2. Click on "merge route" and select your problem map 3. Use the arrows so that the blank single baseboard is attached to your problem map at one end 4. Now delete the blank baseboard leaving your old map as it previously was 5. Change environment parameters (sky, water etc) to suit 6. I found some signals and track markers had moved from their original position - why? 7. Save the map I found this made an unbelievable INCREDIBLE difference to frame rate in Surveyor and I could make changes and save without crashing. Whether this is a permanant solution, is yet to be seen. Cheers Gary Roger